46 ntp configuration, Introduction to ntp, Applications of ntp – H3C Technologies H3C WX3000 Series Unified Switches User Manual
Page 452: Ntp configuration
46-1
46
NTP Configuration
When configuring NTP, go to these sections for information you are interested in:
z
z
z
Configuring NTP Implementation Modes
z
Configuring Access Control Right
z
Configuring NTP Authentication
z
Configuring Optional NTP Parameters
z
Displaying and Maintaining NTP Configuration
z
z
The term switch used throughout this document refers to a switching device in a generic sense or
the switching engine of a WX3000 series.
z
The sample output information in this manual was created on the WX3024. The output information
on your device may vary.
Introduction to NTP
Network time protocol (NTP) is a time synchronization protocol defined in RFC 1305. It is used for time
synchronization between a set of distributed time servers and clients. Carried over UDP, NTP transmits
packets through UDP port 123.
NTP is intended for time synchronization between all devices that have clocks in a network so that the
clocks of all devices can keep consistent. Thus, the devices can provide multiple unified-time-based
applications (See
).
A local system running NTP can not only be synchronized by other clock sources, but also serve as a
clock source to synchronize other clocks. Besides, it can synchronize, or be synchronized by other
systems by exchanging NTP messages.
Applications of NTP
As setting the system time manually in a network with many devices leads to a lot of workload and
cannot ensure accuracy, it is unfeasible for an administrator to perform the operation. However, an
administrator can synchronize the clocks of devices in a network with required accuracy by performing
NTP configuration.
NTP is mainly applied to synchronizing the clocks of all devices in a network. For example: