H3C Technologies H3C WX3000 Series Unified Switches - Manual (Page 369)

37-25
Configuring VLAN Mapping
Refer to VLAN Mapping for information about VLAN mapping.
Configuration prerequisites
z
The ACL rules used for traffic classification are defined. Refer to ACL in H3C WX3000 Series
Unified Switches Switching Engine Configuration Guide for information about defining ACL rules.
z
The VLAN ID to be marked is determined.
z
The ports on which the configuration is to be performed are determined.
Configuration procedure
Follow these steps to configure VLAN mapping:
To do… Use the command… Remarks
Enter system view system-view —
Enter Ethernet port view interface interface-type interface-number —
Configure VLAN mapping
traffic-remark-vlanid inbound acl-rule
remark-vlan vlan-id untagged-packet
Required
By default, VLAN mapping is not
configured.
Configuration example
z
GigabitEthernet 1/0/1 belongs to VLAN 2 and is connected to the 10.1.1.0/24 network segment.
z
Configure VLAN mapping for all the packets sourced from the 10.1.1.0/24 network segment to map
the VLAN IDs of these packets to 1001.
Configuration procedure :
system-view
[device] acl number 2000
[device-acl-basic-2000] rule permit source 10.1.1.1 0.0.0.255
[device-acl-basic-2000] quit
[device] interface GigabitEthernet 1/0/1
[device-GigabitEthernet1/0/1] traffic-remark-vlanid inbound ip-group 2000 remark-vlan 1001
Configuring Queue Scheduling
Refer to Queue Scheduling for information about queue scheduling.
Configuration prerequisites
The algorithm for queue scheduling to be used and the related parameters are determined.
Configuration procedure
Follow these steps to configure SP queue scheduling algorithm:
To do… Use the command… Remarks
Enter system view system-view —
Configure SP queue
scheduling algorithm undo queue-scheduler [ queue-id ]
&<1-8>
Optional
By default, SP queue scheduling
algorithm is adopted on all the output
queues of a port.
Follow these steps to configure SDWRR queue scheduling algorithm: