H3C Technologies H3C WX3000 Series Unified Switches - Manual (Page 669)

67-8
2) Using the if-match interface command will match the routes whose outgoing interface to the next
hop is the specified interface.
3) You are recommended to configure a node to match all routes not passing the preceding nodes in
a route policy.
4) If the cost of a received RIP route is equal to 16, the cost specified by the apply cost command in
a route policy will not be applied to the route, that is, the cost of the route is equal to 16.
5) Using the filter-policy command does not filter redistributed routes.
Troubleshooting IP Route Policy
Symptom
The route policy cannot filter routing information correctly when the routing protocol runs normally.
Analysis
The route policy cannot filter routing information correctly in the following two cases:
z
All nodes in the route policy are in the deny mode.
z
All entries in the IP-prefix list are in the deny mode.
Solution
1) Use the display ip ip-prefix command to display the configuration of the IP-prefix list.
2) Use the display route-policy command to display the configuration of the route policy.