Ap group configuration for inter-ac roaming, Network requirements, Configuration procedure – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 60
48
Figure 25 Deploy the user profile
3.
Verify the configuration:
The AP group in the user profile contains only AP 1, so a client can only access the WLAN through
AP 1.
AP group configuration for inter-AC roaming
Network requirements
As shown in
, AC 1 and AC 2 belong to the same mobility group. Configure an AP group on
the ACs so that a client can still access the WLAN when it moves from between APs.
Figure 26 Network diagram
Configuration procedure
NOTE:
Configuration on the RADIUS server is similar with that in
AP group configuration without roaming
and
is omitted.
1.
Configure AC 1:
# Enable port security.
This manual is related to the following products:
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C WX3000 Series Unified Switches H3C LSWM1WCM10 Access Controller Module H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSWM1WCM20 Access Controller Module H3C LSQM1WCMB0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module H3C WA3600 Series Access Points H3C WA2600 Series WLAN Access Points