beautypg.com

Configuring ac-ap tunnel dual-link – H3C Technologies H3C WX3000E Series Wireless Switches User Manual

Page 31

background image

19

Step Command

Remarks

14.

Specify an IP address for the
management VLAN interface

of the AP.

ip address ip-address { mask |
mask-length }

Optional.
Not configured by default.
The management VLAN of the AP

must be VLAN 1.

15.

Specify an IPv6 address for
the management VLAN

interface of the AP.

ipv6 address { ipv6-address
prefix-length
|

ipv6-address/prefix-length }

Optional.
Not configured by default.
The management VLAN of the AP

must be VLAN 1.

16.

Specify the gateway of the AP. gateway { ip ip- address | ipv6

ipv6-address }

Optional.
Not configured by default.

17.

Save the configuration in AP
configuration view to the

wlan_ap_cfg.wcfg file of the
specified AP or all APs.

save wlan ap provision { all |
name ap-name }

Available in any view.
This command takes effect only on
APs in Run state.
For more information about the
command, see WLAN Command

Reference.

18.

Clear the wlan_ap_cfg.wcfg
file of the specified AP or all

APs.

reset wlan ap provision { all |
name ap-name }

Optional.
Available in any view.
This command takes effect only for

APs in Run state.

Configuring AC-AP tunnel dual-link

Step Command

Remarks

1.

Enter system view.

system-view

N/A

2.

Specify the address of

the backup AC.

wlan backup-ac { ip ipv4-address | ipv6
ipv6-address }

Optional.
By default, no backup AC
address exists.
The backup AC configured in AP

template view takes precedence

over that configured in system
view.

3.

Enter AP template view. wlan ap ap-name [ model model-name [ id

ap-id ] ]

The model name is needed only
when you create a new AP

template.

4.

Specify an IPv4/IPv6
backup AC.

backup-ac { ip ipv4-address | ipv6
ipv6-address }

Optional.
By default, the global backup
AC, if specified, is used by the

AP.
The backup AC configured in AP
template view takes precedence

over that configured in system

view.