H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 48)

36
# Create an AP template named ap1 and its model is WA2100, and configure the serial ID of the
AP as 210235A29G007C000020.
[AC] wlan ap ap1 model WA2100
[AC-wlan-ap-ap1] serial-id 210235A29G007C000020
[AC-wlan-ap-ap1] description L3Office
# Specify the radio type as 802.11g, and channel as 11.
[AC-wlan-ap-ap1] radio 1 type dot11g
[AC-wlan-ap-ap1-radio-1] channel 11
# Bind radio policy radiopolicy1 to radio 1, and bind service template 1 to radio 1.
[AC-wlan-ap-ap1-radio-1] radio-policy radiopolicy1
[AC-wlan-ap-ap1-radio-1] service-template 1
[AC-wlan-ap-ap1-radio-1] radio enable
2. Verify the configuration:
{
The clients can associate with the APs and then access the WLAN.
{
You can use the display wlan client command to view the online clients.
WLAN auto-AP configuration example
Network requirements
As shown in Figure 17 , an AC is connected to a Layer 2 switch. AP 1 (serial ID SZ001) and AP 2 (serial
ID SZ002) are connected to the AC through the L2 switch. AP1, AP 2 and the AC are in the same network.
AP 1 and AP 2 get their IP address from the DHCP server. Enable the auto-AP function to enable APs to
automatically connect to the AC.
Figure 17 Network diagram
Configuration procedure
1. Configure the AC:
# Create a WLAN ESS interface.
system-view
[AC] interface WLAN-ESS 1
[AC-WLAN-ESS1] quit
# Define a WLAN service template of clear type, configure its SSID as service, and bind the
WLAN-ESS interface to this service template.