Verifying the configuration, Network requirements, Configuration procedure – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 143
131
# Create an AP template named ap2 and its model is WA2100, and configure the serial ID of AP 2 as
210235A29G007C000021.
[AC] wlan ap ap2 model WA2100
[AC-wlan-ap-ap2] serial-id 210235A29G007C000021
[AC-wlan-ap-ap2] radio 1 type dot11g
# Bind service template 1 to radio 1 of AP 2.
[AC-wlan-ap-ap2-radio-1] service-template 1
[AC-wlan-ap-ap1-radio-1] radio enable
[AC-wlan-ap-ap2-radio-1] return
Verifying the configuration
Client 1 and Client 2 are associated with AP 1. When the maximum traffic threshold and load gap are
reached on AP 1, Client 3 is associated with AP 2.
Configuring group-based session-mode load balancing
Network requirements
•
As shown in
, all APs operate in 802.11g mode. Client 1 is associated with AP 1. Client 2
through Client 6 are associated with AP 2, and no client is associated with AP 3.
•
Configure session-mode load balancing on the AC. The maximum number of sessions is 5 and the
maximum session gap is 4.
•
Session-mode load balancing is required on only radio 1 of AP 1 and radio 1 of AP 2. Therefore,
add them into a load balancing group.
Figure 69 Network diagram
Configuration procedure
1.
Configure APs on the AC:
# Create a WLAN ESS interface.
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C WX3000 Series Unified Switches H3C LSWM1WCM10 Access Controller Module H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSWM1WCM20 Access Controller Module H3C LSQM1WCMB0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module H3C WA3600 Series Access Points H3C WA2600 Series WLAN Access Points