Displaying and maintaining user isolation, Configuring ap group for ap based access control, Configuring an ap group – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 42
30
Displaying and maintaining user isolation
Task Command
Remarks
Display user isolation statistics.
display user-isolation statistics
[ vlan vlan-id ] [ | { begin | exclude
| include } regular-expression ]
Available in any view
Clear user isolation statistics.
reset user-isolation statistics [ vlan
vlan-id ]
Available in user view
Configuring AP group for AP based access control
Some wireless service providers need to control the access positions of clients. For example, as shown
in
, to meet security or billing needs, connect wireless clients 1, 2 and 3 to the wired network
through APs 1, 2 and 3 respectively. To achieve this, you can configure an AP group and then apply the
AP group in a user profile.
Figure 13 Client access control
Configuring an AP group
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Create an AP group and
enter AP group view.
wlan ap-group value N/A
3.
Add specified APs into the
AP group.
ap template-name-list
No AP is added by default.
You can use this command
repeatedly to add multiple APs, or
add up to 10 APs in one
command line.
A nonexistent AP can be added.
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C WX3000 Series Unified Switches H3C LSWM1WCM10 Access Controller Module H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSWM1WCM20 Access Controller Module H3C LSQM1WCMB0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module H3C WA3600 Series Access Points H3C WA2600 Series WLAN Access Points