H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 171)

159
example), the request is accepted. The priority is decreased for packets from the clients exceeding the
maximum number of high-priority AC clients.
SVP service configuration example
Network requirements
As shown in Figure 81 , AC is connected to L2 switch. AP and AC are in the same network. Configure the
SVP service, so that SVP packets are assigned to the AC-VO queue on AP.
To guarantee the highest priority for the AC-VO queue, set ECWmin and ECWmax to 0 for the AC-VO
queue of AP.
Figure 81 Network diagram
Configuration procedure
system-view
# Create interface WLAN-ESS 1.
[AC] interface WLAN-ESS 1
[AC-WLAN-ESS1] quit
# Configure a clear-type WLAN service template, configure its SSID as market, and bind WLAN-ESS 1
to the service template.
[AC] wlan service-template 1 clear
[AC-wlan-st-1] ssid market
[AC-wlan-st-1] bind WLAN-ESS 1
[AC-wlan-st-1] authentication-method open-system
[AC-wlan-st-1] service-template enable
# Configure a radio policy radiopolicy1, and enable WMM for the radio policy.
[AC] wlan radio-policy radiopolicy1
[AC-wlan-rp-radiopolicy1] wmm enable
# Assign SVP packets to the AC-VO queue.
[AC-wlan-rp-radiopolicy1] wmm svp map-ac ac-vo
# Create a template named ap1, configure the model name as WA2100, and configure the serial ID as
210235A29G007C000020.
[AC] wlan ap ap1 model WA2100
[AC-wlan-ap-ap1] serial-id 210235A29G007C000020
# Bind service template 1 and radio policy radiopolicy1 to interface Radio 1.
[AC-wlan-ap-ap1] radio 1 type dot11a
[AC-wlan-ap-ap1-radio-1] radio-policy radiopolicy1
[AC-wlan-ap-ap1-radio-1] service-template 1
[AC-wlan-ap-ap1-radio-1] radio enable
If a non-WMM client goes online and sends SVP packets to the AC, the SVP packets will be assigned to
the AC-VO queue.