H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 222)

210
Configure the following optimization features on AP 1:
• Reject wireless clients with low RSSI
• Ignore weak signals
• Enable traffic shaping based on link status
• Enable fair scheduling
Figure 103 Network diagram
Configuration procedure
1. Configure IP addresses and masks for devices as shown in Figure 103 . (Details not shown.)
2. Configure the AC:
Configure a WLAN service. For more information about WLAN service configuration, see
"Configuring WLAN services." The following configures a clear-type WLAN service.
# Add interface WLAN-ESS 1 to VLAN 100.
system-view
[AC] interface WLAN-ESS 1
[AC-WLAN-ESS1] port access vlan 100
[AC-WLAN-ESS1] quit
# Create clear-type service template 1, specify its SSID as Clear-Test, bind the template with
WLAN-ESS1, and enable the template.
[AC] wlan service-template 1 clear
[AC-wlan-st-1] ssid Clear-Test
[AC-wlan-st-1] bind WLAN-ESS 1
[AC-wlan-st-1] service-template enable
[AC-wlan-st-1] quit
3. Create a configuration file named aplocalrule.txt for AP 1:
# The configuration file contains the following settings.
wlan option client-reject 15 //Reject clients with RSSI lower than 15
wlan option signal-ignore 15 //Ignore signals weaker than 15
wlan option traffic-shaping enable //Enable traffic shaping based on link status
wlan option fair-schedule enable //Enable fair scheduling
4. Configure the APs:
# Create AP template ap1 with the model as WA2100, specify the serial ID as
210235A29G007C000020, and bind the configuration file aplocalrule.txt to AP 1.
[AC] wlan ap ap1 model wa2100
L2 Switch
AC
10.10.1.1/24
DHCP server
10.10.1.2/24
AP 1
AP 2
Client 2
Client 1