H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 109)

97
[AC2-radius-rad] quit
# Create ISP domain cams, and use RADIUS scheme rad as the AAA methods.
[AC2] domain cams
[AC2-isp-cams] authentication default radius-scheme rad
[AC2-isp-cams] authorization default radius-scheme rad
[AC2-isp-cams] accounting default radius-scheme rad
[AC2-isp-cams] quit
# On interface WLAN-ESS 1, configure the 802.1X mandatory authentication domain as cams.
[AC1] interface WLAN-ESS 1
[AC1-WLAN-ESS1] dot1x mandatory-domain cams
[AC1-WLAN-ESS1] quit
# Configure AP 2: Create an AP template named ap2 and its model is WA2100, and configure the
serial ID of AP 2 as 2210235A22W0076000103.
[AC2] wlan ap ap2 model WA2100
[AC2-wlan-ap-ap2] serial-id 210235A22W0076000103
[AC2-wlan-ap-ap2] radio 1 type dot11g
# Bind service template inter-roam to radio 1 of AP 2 (Inter-AC roaming requires consistent SSIDs
of APs. Therefore, radio 1 of AP 2 should be bound to service template inter-roam.).
[AC2-wlan-ap-ap2-radio-1] service-template 1
[AC2-wlan-ap-ap2-radio-1] radio enable
[AC2-wlan-ap-ap2-radio-1] quit
[AC2-wlan-ap-ap2] quit
# Create mobility group roam, specify the tunnel source IP as 10.18.1.2, and specify a member
with IP address 10.18.1.1.
[AC2] wlan mobility-group roam
[AC2-wlan-mg-roam] source ip 10.18.1.2
[AC2-wlan-mg-roam] member ip 10.18.1.1
[AC2-wlan-mg-roam] mobility-group enable
3. Verify the configuration:
You can use the display wlan client roam-out command on AC 1 to display roamed out client
information, and use the display wlan client roam-in command on AC 2 to display roamed in
client information. You can also use the display wlan client roam-track mac-address command to
view client roaming track information on AC 1.