beautypg.com

Configuring session mode load balancing, Configuring traffic mode load balancing, Configuring group-based load balancing – H3C Technologies H3C WX3000E Series Wireless Switches User Manual

Page 127: Prerequisites, Configuring a load balancing group

background image

115

Configuring session mode load balancing

NOTE:

If the AC has a load balancing mode configured but has no load balancing group created, it
adopts

AP-based load balancing

by default.

To configure session mode load balancing:

Step Command

Remarks

1.

Enter system view.

system-view

N/A

2.

Enter RRM view.

wlan rrm

N/A

3.

Configure session mode load

balancing.

load-balance session value [ gap
gap-value ]

By default, no session
threshold is set.

Configuring traffic mode load balancing

NOTE:

If the AC has a load balancing mode configured but has no load balancing group created, it
adopts

AP-based load balancing

by default.

To configure traffic mode load balancing:

Step Command

Remarks

1.

Enter system view

system-view

N/A

2.

Enter RRM view

wlan rrm

N/A

3.

Configure traffic mode load
balancing

load-balance traffic value [ gap
gap-value ]

By default, no traffic threshold is
set.

Configuring group-based load balancing

Prerequisites

Before you configure load balancing, make sure of the following:

The target APs are associated to the same AC.

The clients can find the APs.

The fast association function is disabled. By default, the fast association function is disabled. For
more information about fast association, see "Configuring WLAN services."

A load balancing mode has been configured. For more information, see "

Configuring a load

balancing mode

."

Configuring a load balancing group

Step Command

Remarks

1.

Enter system view.

system-view

N/A