Verifying the configuration, Network requirements, Configuration procedure – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 145
133
3.
Configure group-based session-mode load balancing:
# Create load balancing group 1.
[AC] wlan load-balance-group 1
# Add radio 1 of AP 1 and radio 1 of AP 2 to the load balancing group.
[AC-wlan-lb-group-1] ap ap1 radio 1
[AC-wlan-lb-group-1] ap ap2 radio 1
Verifying the configuration
•
Radio 1 of AP 1 and radio 1 of AP 2 are in the same load balancing group, and the radio of AP
3 does not belong to any load balancing group. Load balancing takes effect on only radios in a
load balancing group, so AP 3 does not take part in load balancing.
•
Assume Client 7 wants to associate with AP 2. The number of clients associated with radio 1 on AP
2 reaches 5, and the load gap between AP 2 and AP 1 reaches 4, so Client 7 is associated with
AP 1.
Configuring group-based traffic-mode load balancing
Network requirements
•
As shown in
, all APs operate in 802.11g mode. Client 1 and Client 2 are associated with
AP 1, and no client is associated with AP 2 and AP 3.
•
Configure traffic-mode load balancing on the AC. The traffic threshold is 10% and the maximum
traffic gap is 40%.
•
Traffic-mode load balancing is required on only radio 1 of AP 1 and radio 1 of AP 2.
Figure 70 Network diagram
Configuration procedure
1.
Configure APs on the AC:
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C WX3000 Series Unified Switches H3C LSWM1WCM10 Access Controller Module H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSWM1WCM20 Access Controller Module H3C LSQM1WCMB0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module H3C WA3600 Series Access Points H3C WA2600 Series WLAN Access Points