H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 136)

124
# Create radio 1, specify channel 149, map mesh profile 1 to the radio, and then enable the
radio.
[AC-wlan-ap-ap1] radio 1 type dot11a
[AC-wlan-ap-ap1-radio-1] channel 149
[AC-wlan-ap-ap1-radio-1] mesh-profile 1
[AC-wlan-ap- p1-radio-1] radio enable
[AC-wlan-ap-ap1-radio-1] quit
# Enable the mesh portal service for MPP.
[AC-wlan-ap-ap1] portal-service enable
[AC-wlan-ap-ap1] quit
3. Configure AP 2:
# Create AP template ap2 of model WA2620X-AGNP, and configure its serial ID.
[AC] wlan ap ap2 model wa2620x-agnp
[AC-wlan-ap-ap2] serial-id 21023529G007C000020
# Create radio 1, specify channel 149 for it, and map mesh profile 1 to it, and then enable the
radio.
[AC-wlan-ap-ap2] radio 1 type dot11a
[AC-wlan-ap-ap2-radio-1] channel 149
[AC-wlan-ap-ap2-radio-1] mesh-profile 1
[AC-wlan-ap-ap2-radio-1] radio enable
[AC-wlan-ap-ap2-radio-1] return
After the configuration, a mesh link will be established between the AP 1 and AP 2, and they can
ping each other.
4. Configure mesh auto DFS:
# Enable mesh auto DFS.
system-view
[AC] wlan rrm
[AC-wlan-rrm] mesh calibrate-channel self-decisive
Verifying the configuration
Use the display wlan mesh calibrate-channel history command to view channel adjustment history
information. When a trigger condition is met, the AC changes the channel, for example, from channel
149 to channel 153 after the calibration interval.
Configuring auto TPC
Network requirements
As shown in Figure 65 , AP 1 through AP 3 are connected to AC. It is required to configure auto TPC and
Specify the maximum number of neighbors as 3 on AC. In this way, when AP4 joins, AC will perform
auto TPC.