Displaying and maintaining wlan sniffer, Wlan sniffer configuration example, Network requirements – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 203: Configuration procedure
191
Displaying and maintaining WLAN sniffer
Task Command
Remarks
Display information about WLAN
sniffer enabled APs.
display wlan capture [ | { begin |
exclude | include }
regular-expression ]
Available in any view
WLAN sniffer configuration example
Network requirements
As shown in
, on the AC, enable WLAN sniffer for an AP to capture wireless packets.
Figure 97 Network diagram
Configuration procedure
NOTE:
To enable WLAN sniffer on a radio, the AP must operate in normal mode and must be in Run state, and
the working channel of the radio must be manually specified. The working channel for WLAN sniffer in
this example is 11.
1.
Configure the WLAN sniffer function:
# Enable WLAN sniffer on Radio 2 of the AP named captureap.
[AC] wlan capture start ap captureap radio 2
2.
Verify the configuration:
# Display information about the AP that is capturing packets. The output shows that Radio 2 on the
AP is capturing packets.
[AC] display wlan capture
WLAN Capture
--------------------------------------------------------------------------------
AP : captureap
Radio : 2
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C WX3000 Series Unified Switches H3C LSWM1WCM10 Access Controller Module H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSWM1WCM20 Access Controller Module H3C LSQM1WCMB0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module H3C WA3600 Series Access Points H3C WA2600 Series WLAN Access Points