H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 55)

43
[AC1-wlan-ap-ap1] serial-id 210235A29G007C000020
[AC1-wlan-ap-ap1] description L3office
# Specify the radio type as 802.11g, and channel as 11.
[AC1-wlan-ap-ap1] radio 1 type dot11g
[AC1-wlan-ap-ap1-radio-1] channel 11
# Bind radio policy radiopolicy1 to radio 1, and bind service template 1 to radio 1.
[AC1-wlan-ap-ap1-radio-1] radio-policy radiopolicy1
[AC1-wlan-ap-ap1-radio-1] service-template 1
[AC1-wlan-ap-ap1-radio-1] radio enable
[AC1-wlan-ap-ap1-radio-1] return
Verifying the configuration
After AP 1 and AP 2 are rebooted, they can establish an AC-AP tunnel connection with AC 1.
802.11n configuration example
Network requirements
As shown in Figure 21 , deploy an 802.11n network to provide high-bandwidth access for multi-media
applications. The AP provides a plain-text wireless service with SSID 11nservice. 802.11gn is adopted to
inter-work with existing 802.11g networks.
Figure 21 Network diagram
Configuration procedure
1. Configure the AC:
# Create a WLAN-ESS interface.
system-view
[AC] interface wlan-ess 1
[AC-WLAN-ESS1] quit
# Configure a service template of clear type, configure the SSID of the service template as
11nservice, and bind the WLAN-ESS interface with the service template.
[AC] wlan service-template 1 clear
[AC-wlan-st-1] ssid 11nservice
[AC-wlan-st-1] bind WLAN-ESS 1
[AC-wlan-st-1] authentication-method open-system
[AC-wlan-st-1] service-template enable
[AC-wlan-st-1] quit
# Configure the AP on the AC, and the AP must support 802.11n.
[AC] wlan ap ap1 model WA2610E-AGN
[AC-wlan-ap-ap1] serial-id 210235A29G007C000020
# Configure the radio of the AP to operate in 802.11gn mode.
[AC-wlan-ap-ap1] radio 1 type dot11gn
# Bind the service template to radio 1.