H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 221)

209
Configuration procedure
1. Configure IP addresses and masks for devices as shown in Figure 102 . (Details not shown.)
2. Configure the AC:
Configure a WLAN service. For more information about WLAN service configuration, see
"Configuring WLAN service." The following configures a clear-type WLAN service.
# Add interface WLAN-ESS 1 to VLAN 100.
system-view
[AC] interface WLAN-ESS 1
[AC-WLAN-ESS1] port access vlan 100
[AC-WLAN-ESS1] quit
# Create clear-type service template 1, specify its SSID as Clear-Test, bind the template with
WLAN-ESS1, and enable the template.
[AC] wlan service-template 1 clear
[AC-wlan-st-1] ssid Clear-Test
[AC-wlan-st-1] bind WLAN-ESS 1
[AC-wlan-st-1] service-template enable
[AC-wlan-st-1] quit
3. Configure the APs:
Configure all the APs on the AC. The following takes an AP as an example.
# Create AP template ap1 with the model as WA2620-AGN, and specify the serial ID as
219801A0A8909AG00046.
[AC] wlan ap ap1 model wa2620-agn
[AC-wlan-ap-ap1] serial-id 219801A0A8909AG00046
# Apply the service template 1 to radio 1 and enable radio 1.
[AC-wlan-ap-ap1] radio 1
[AC-wlan-ap-ap1-radio-1] service-template 1
[AC-wlan-ap-ap1-radio-1] radio enable
# Apply the service template 1 to radio 2 and enable radio 2.
[AC-wlan-ap-ap1-radio-1] radio 2
[AC-wlan-ap-ap1-radio-2] service-template 1
[AC-wlan-ap-ap1-radio-2] radio enable
[AC-wlan-ap-ap1-radio-2] quit
[AC-wlan-ap-ap1] quit
4. Configure WLAN optimization:
# Enable 802.11n packet suppression and set the maximum number of MPDUs aggregated in an
A-MPDU as six, and set the maximum A-MPDU length as 5000 bytes.
[AC] wlan option dot11n-restraint packet-number 6 packet-length 5000
# Enable traffic shaping based on link status.
[AC] wlan option traffic-shaping enable
Optimizing some APs in a WLAN
Network requirements
As shown in Figure 103 , all the clients and APs get their IP addresses from the DHCP server. Client 1 is
close to AP 1, and Client 2 is close to AP 2.