H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 217)

205
• Enable traffic shaping based on link status
• Enable fair scheduling
Figure 99 Network diagram
Configuration procedure
1. Configure IP addresses and masks for devices as shown in Figure 99 . (Details not shown.)
2. Configure the AC:
Configure a WLAN service. For more information about WLAN service configuration, see
"Configuring WLAN services". The following configures a clear-type WLAN service.
# Add interface WLAN-ESS 1 to VLAN 100.
system-view
[AC] interface WLAN-ESS 1
[AC-WLAN-ESS1] port access vlan 100
[AC-WLAN-ESS1] quit
# Create clear-type service template 1, specify its SSID as Clear-Test, bind the template with
WLAN-ESS1, and enable the template.
[AC] wlan service-template 1 clear
[AC-wlan-st-1] ssid Clear-Test
[AC-wlan-st-1] bind WLAN-ESS 1
[AC-wlan-st-1] service-template enable
[AC-wlan-st-1] quit
3. Configure the APs:
Configure all the APs on the AC. The following takes an AP as an example.
# Create AP template ap1 with the model as WA2100, and specify the serial ID as
210235A29G007C000020.
[AC] wlan ap ap1 model wa2100
[AC-wlan-ap-ap1] serial-id 210235A29G007C000020
# Apply the service template 1 to radio 1 and enable the radio.
[AC-wlan-ap-ap1] radio 1