Teac GigaStudio 3 - Manual (Page 85)

84 85
How to ReWire GigaStudio 3.0 with Live 2 or Live 3
This procedure is based on Live version 2 or 3 for Windows XP.
1. If you have not used Live yet, please be sure to run it at least once before proceed-
ing. This is so that Live can install its ReWire engine in your system.
2. Go to Live’s In/Out View and select Giga3 as the “In Type”.
3. Enable Live’s monitoring switch.
4. Launch GigaStudio 3.0
5. Select the desired ReWire Channels in Live´s In Channel menu if you have devices
in GigStudio routed to specific channels other than the DSP Station Output Master
channels 1:2.
Gigastudio 3.0 is now ready to run in ReWire Slave mode, while Live is the ReWire
Master. You can record the GigaStudio ReWire input in Live as you would with any
other input in Live. (For more application specific information see the recording
section of the Live manual).
To successfully disconnect the ReWire connection from Live you must always quit
Gigastudio first.
How to ReWire GigaStudio 3.0 with Acid 4.0
This procedure is based on ACID Pro version 4.0 for Windows XP. No other versions of
Acid have support for ReWire.
1. If you have not used Acid yet, please be sure to run it at least once before proceed-
ing. This is so that Acid can install its ReWire engine in your system.
2. Go to Acid’s Insert menu and select Soft Synth. Go to the ReWire tab and select an
available Giga3 ReWire device.
3. Scroll the Acid mixer window to find the new stereo buss for the Giga3 ReWire de-
vice.
4. Launch GigaStudio 3.0.
5. Select the desired ReWire MIDI channels in Acid’s Soft Synth Properties window if
you have devices in GigaStudio routed to specific channels other than the DSP Sta-
tion Output Master channels 1:2.
6. Add more stereo busses in Acid’s Project Audio Properties for additional outputs
routed from the GigaStudio DSP Station.
Gigastudio 3.0 is now in ReWire Slave mode, while Acid is the ReWire Master. You can
render the GigaStudio ReWire input in Acid as you would with any other track in