Teac GigaStudio 3 User Manual
Page 173
172
173
Vel scale (velocity scale)
This value is used to scale the currently selected velocity curve in order to specify a
much larger number of filter velocity responses. For example, if you desire the filter to
scale from a low cutoff to fully open within the lowest velocity range, the filter response
can be scaled to open more quickly by entering values above 20 (up to 127). Values below
20 will cause the filter to open more slowly over velocity yielding a darker response.
The range is 0-127 with a default value of 20. This parameter is only available if the
Cutoff Controller is set to “None”.
Break pt (break point)
Adjust this value to set the breakpoint for the filter keyboard tracking. This scales the
cutoff frequency based on key position relative to the assigned Breakpoint value (MIDI
note number).
With the break point function, you can have the filter go from dark to bright as you
play from one end of the keyboard to the other. Range is from 0-127 with a default value
of 60 (Middle C).
Fc MIDI Ctrl (filter cutoff MIDI controller)
Instead of setting the cutoff frequency, this parameter allows you to assign a MIDI
controller to the Cutoff Frequency for real-time continuous control. This overrides the
Cutoff Frequency setting, which will be disabled once you assign a MIDI controller here.
Res MIDI Ctrl (resonance MIDI controller)
Assign a real-time MIDI controller to the filter resonant frequency.
Vel curve (velocity curve)
Select how the filter responds to the incoming velocity:
• 0-Non linear
• 1-Linear
• 2-Special