Teac GigaStudio 3 - Manual (Page 225)

224 225
Divider at 500Hz
Reverb Parameters:
Room Size:
This setting determines the size of the room. A lager size will give you a much bigger
sound. A smaller room size will give you a more direct sound and it will decay faster.
Pre Delay:
This sets the amount of time between the direct signal and the start of the reverb. It
allows you to hear a few milliseconds of dry signal before the reverb signal kicks in. This
can help move the sound in the stereo spectrum and make the sound a bit more clear.
It can also enhance the realism of instruments in a hall. Just like in the real hall, you
will first hear the direct sound followed by the room ambience.
Damping:
Air will absorb high frequencies more than low frequencies and it delays the high fre-
quency a little bit as well. The further away that a sound it, the less high frequency con-
tent you will hear. Using the Damping control, you can push the sound further away or