Teac DS-M7.1 Setup Guide User Manual

Setting up the tascam ds-m7.1

Setting up the TASCAM DS-M7.1

TASCAM DS-M7.1 Setup Guide

Before you start using the TASCAM DS-M7.1 to help you with the monitoring of your surround mix, there are a

few operations to be carried out which will help you use the unit most effectively.

These are: trimming each channel so that each channel is correctly balanced relative to the others for your listen-

ing position, adjusting the delay for the channels to avoid phase delays, etc., and setting up the overall SPL (loud-

ness) of the unit.
First, you should set up the DS-M7.1 so that your system is something like the one pictured here. For full details,

see the Reference Manual, paying particular attention to the notes regarding word sync. Also note that this illus-

tration shows a 5.1 system with no insert loop attached to the DS-M7.1. Your setup may differ from this, but the

principles will be the same (the connections between the monitoring amp system and the monitor speakers are

omitted for reasons of clarity.

Note that the connections between the master recorder and the tracking recorder are bidirectional, as are the con-

nections between the console and the DS-M7.1.

�� 

��

�

��

�

�� 

��
��

�� 

��

�� 

MASTER

RECORDER I/O

TRK RECORDER

I/O

CONSOLE I/O

MONITOR

OUTPUTS

(ANALOG)

D00697500A