Comtech EF Data CDM-710G - Manual (Page 86)

CDM-710G High-Speed Satellite Modem Revision 1
Front Panel Operation MN-CDM710G
6–10
If Ethernet CONFIG: Æ MAC is selected:
M&C Port MAC Address:
00-06-B0-00-56-33
This is a ‘status only’ display. Press
ENTER
or
CLEAR
to return to the previous menu.
Note: The preceding address is representative of a typical MAC address.
If Ethernet CONFIG: Æ SNMP is selected:
SNMP:
Community Traps (LRE)
This is a ‘status only’ message. Submenus enable setting of the destination IP address for SNMP traps.
Press
ENTER
or
CLEAR
to return to the previous menu.
If SNMP Æ Community is selected:
SNMP Community:
Read ( E )
If Community ÆRead is selected:
Read Community: ( E )
public
If SNMP Æ Traps is selected:
SNMP Trap IP Address:
IP1 IP2 Version
Select IP1, IP2, or Version using the W X arrow keys, then press
ENTER
.
If SNMP Trap IP Address: Æ IP1 or IP2 is selected:
Trap ID #X:
000.000.000.000 ( E )
To edit the SNMP Trip IP#1 or IP#2 Address, use the W X arrow keys to select the digit to be
edited, then use the ST arrow keys to change the value of the digit. Press
ENTER
when done.
If SNMP Trap IP Address: Æ Version is selected:
Trap Version:
SNMPv1 SNMPv2 (E )
Select SNMPv1 or SNMPv2 using the W X arrow keys, then press
ENTER
.