Comtech EF Data CDM-710G - Manual (Page 84)

CDM-710G High-Speed Satellite Modem Revision 1
Front Panel Operation MN-CDM710G
6–8
6.3.1.1 (CONFIG:) Remote Control
Remote Control:
Local Serial Ethernet
Select Local, Serial or Ethernet using the W X arrow keys, then press
ENTER
. Note the
following:
SELECTION ACTION
Local Remote control is disabled. Remote monitoring is still possible.
Serial RS232, RS485-2W, and RS485-4W menus are accessed.
Ethernet Additional sub-menus will be displayed.
(CONFIG:) Remote Control Æ Local
IMPORTANT
When Local is selected, remote control is disabled and local control enabled.
Once ENTER is pressed, the user is returned to the CONFIG: menu.
When Remote is selected, menu operations associated with Local control are
disabled, and the user may see the following messages and prompts when
menu or command access associated with Local control is attempted (follow
the prompt as shown):
THIS UNIT IS CURRENTLY
IN REMOTE MODE!!
DO YOU WANT IN LOCAL
MODE? ENT=Yes CLR=No
(CONFIG:) Remote Control
Æ Serial
Serial CONFIG:
Interface Baudrate (E)
Select Interface or Baudrate using the W X arrow keys, then press
ENTER
.
If Serial CONFIG: Æ Interface is selected:
M&C Bus Interface: RS232
RS485-2W RS485-4W (E)
Select RS232 or RS485-2W (2-wire) or RS485-4W (4-wire) using the W X arrow keys, then
press
ENTER
.
Note: At this point the user will be further prompted to enter the bus address.