Comtech EF Data CDM-710G - Manual (Page 100)

CDM-710G High-Speed Satellite Modem Revision 1
Front Panel Operation MN-CDM710G
6–24
If Intfc1 Port1 Tx: Æ Ena/Dis is selected:
Intfc1 Port1 Status
Enable Disable ( E)
Using the W X arrow keys, select Enable to activate the transmit (Tx) side of Port1, or select
Disable to de-activate the transmit (Tx) side of Port1 and change the Data Rate to 0, then press
ENTER
.
If Intfc1 Port1 E3/T3/STS1: Æ Rx is selected:
Intfc1 Port 1 Rx:
Inv Data Buf Clk Ena/Dis
Select Inv, Data, Buf, Clk, or Ena/Dis using the W X arrow keys, then press
ENTER
.
If Intfc1 Port1 Rx: Æ Inv is selected:
Intfc1 Port 1 Rx Data:
Normal Inverted ( E)
Select Normal or Inverted using the W X arrow keys, to control data inversion, then press
ENTER
.
If Intfc1 Port1 Rx: Æ Data is selected:
Intfc1 Port 1 Data Rate
Rx: 34.368000 (E)
Intfc1 Port 1 Data Rate
Rx: Disabled (E)
This is a read-only status window to display the data selected via the Intfc1 Port1: Æ Type
menu. When Port1 Rx is enabled or disabled via Intfc1 Port1 Rx: Æ Ena/Dis (see next section),
that status is reflected in this display. Note the following:
• When Port1 Rx is enabled, the Data Rate associated with Port 1 is displayed, as shown in
the top example.
• When Port1 Rx is disabled, that status is reflected in this display, as shown in the bottom
example.
Press
ENTER
or
CLEAR
to return to the previous menu.
If Intfc1 Port1 Rx: Æ Buf is selected:
Intfc1 Port1 Rx Buffer:
Frame-Type Size ReCenter
Select Frame-Type, Size, or ReCenter using the W X arrow keys, then press
ENTER
.