Comtech EF Data CDM-710G - Manual (Page 124)

CDM-710G High-Speed Satellite Modem Revision 1
Front Panel Operation MN-CDM710G
6–48
6.3.5.1 (SELECT:) Save/Load
Æ Save
Save Config to Loc: 9
Empty
( E)
Using Loc 9: as the example, if Save is selected and no configuration has been saved, the second
line reads ‘Empty’, as shown in the preceding example.
However, if the selected Loc: 9 already contains data, what displays is similar to the next example:
Save Config to Loc: 9
01:02:43 05/08/05 ( E)
The user is shown the time and date stamp of the previously stored configuration, for identification
purposes.
Select the location where the current configuration is to be stored using the ST arrow keys, then
press
ENTER
. There are 10 available locations, numbered 0 through 9.
If the selected location does not contain a previously stored configuration, the following screen is
displayed:
New Config has been
Saved to Loc 9 (E)
However, if the selected location does contain a previously stored configuration, the following
screen is displayed:
Loc 0 Contains Data !
Overwrite? NO YES (E)
Selecting Yes overwrites the existing configuration at the selected location.
Select No or Yes using the
W X arrow keys, then press
ENTER
.
6.3.5.2 (SELECT:) Save/Load Æ Load
Load Config from Loc: 9
11:02:43 05/08/05 (
E)
Using Loc: 9 as the example, if Load is selected and there is a configuration stored at the selected
location, what displays is similar to the preceding example. Note that the stored configuration is
identified with a date and time stamp.
If the selected location contains no data, what displays is similar to the next example:
Load Config from Loc: 9
Empty
( E)
Select the location from where the current configuration is to be loaded using the ST arrow keys,
then press
ENTER
. There are 10 locations numbered 0 through 9..