Comtech EF Data CDM-710G - Manual (Page 125)

CDM-710G High-Speed Satellite Modem Revision 1
Front Panel Operation MN-CDM710G
6–49
If the selected location contains valid data, what displays is similar to the following example:
New Config has been
Loaded from Loc # (E)
Press ENTER or
CLEAR
to return to the previous menu.
If the selected location contains invalid data, what displays is similar to the next example:
Warning! Loc 9 Contains
No Data! (E)
Press ENTER or
CLEAR
to return to the previous menu.
6.3.6 SELECT: Util (Utility)
UTIL: RT-Clk Ref ID
Display Firmware FAST
Select RT-Clk, Ref, ID, Display, Firmware, or FAST using the W X arrow keys, then press
ENTER
.
6.3.6.1 (SELECT:) UTIL
Æ RT-Clk
Edit Real-Time Clock:
10:23:51 23/05/06 ( E)
Edit the time and date settings of the real-time clock. Use the W X arrow keys to select the digit.
Use the ST arrow keys to change the value of the digit, then press
ENTER
.
Note: In accordance with international convention, the date is shown in DAY/MONTH/YEAR
format.
6.3.6.2 (SELECT:) UTIL
Æ Ref
Internal 10 MHz Ref Freq
Fine Adjust:+1911
This menu provides a fine adjustment for the internal 10 MHz reference.
For ‘Tx Only’ or ‘Full Duplex’ units, use the Tx IF Carrier to check the reference frequency by
first placing the unit in the
Tx-CW mode from the
Test
menu.
In ‘Rx Only’ units, 10 MHz is available at J6-8 or J6-9 only while within the
Utility: Ref
menu.