Comtech EF Data CDM-710G - Manual (Page 103)

CDM-710G High-Speed Satellite Modem Revision 1
Front Panel Operation MN-CDM710G
6–27
6.3.1.5 CONFIG: Int1 (CDI-60 HSSI Interface Only)
Note: The menu branch and submenus depicted in this section are dependent on the presence
of the CDI-60 HSSI Interface card, installable in Interface Slot 1 only.
Intfc1 HSSI:
Tx Rx CTS/RTS (E)
Select Tx, Rx, or CTS/RTS using the W X arrow keys, then press
ENTER
.
(CONFIG:) Intfc1 HSSI
Æ Tx
Intfc1 Tx
Data Clock Enable (E)
Select Data, Clock, or Enable using the W X arrow keys, then press
ENTER
.
If Intfc1 Tx Æ Data is Selected:
Intfc1 Tx Data:
Datarate Invert (E)
Select Datarate or Invert using the W X arrow keys, then press
ENTER
.
If Intfc1 Tx Data: Æ Datarate is selected:
Intfc1 Data Rate:
Tx: 032.000000 Mbps
This is a read-only status message that indicates the Data Rate of the transmit MPEG-2 transport
stream. Press
ENTER
or
CLEAR
to return to the previous menu.
If Intfc1 Tx Data: Æ Invert is selected:
Intfc1 Tx Data Invert:
Normal Inverted (E)
To control data inversion (added for compatibility with certain older equipment), select Normal
or Inverted using the
W X arrow keys, then press
ENTER
.
If Intfc1 Tx Æ Clock is Selected:
Intfc1 Tx Clock:
Normal Inverted (E)
To control clock inversion (added for compatibility with certain older equipment), select Normal
or Inverted using the
W X arrow keys, then press
ENTER
.