Comtech EF Data CDM-710G - Manual (Page 107)

CDM-710G High-Speed Satellite Modem Revision 1
Front Panel Operation MN-CDM710G
6–31
This display is read-only. If Tx: Disabled is displayed, the port is turned off:
Intfc2 Data Rate:
Tx: Disabled (E)
Press
ENTER
or
CLEAR
to return to the previous menu.
If Intfc2 Tx: Æ Enable is selected:
Intfc2 Tx Enable:
Enable Disable ( E)
Using the W X arrow keys, select Enable to activate the transmit (Tx) side of this interface, or
select Disable to de-activate the transmit side of this interface. Press
ENTER
when done.
(CONFIG:) Intfc2 Gigabit Ethernet
Æ Rx
Intfc2 Rx:
Data Enable ( E)
Select Data or Enable using the W X arrow keys, then press
ENTER
.
If Intfc2 Rx: Æ Data is selected:
Intfc2 Data Rate:
Rx:075.000000 Mbps (E)
This display is read-only. If Rx: Disabled is displayed, the port is turned off:
Intfc2 Data Rate:
Rx: Disabled (E)
Press
ENTER
or
CLEAR
to return to the previous menu.
If Intfc2 Rx: Æ Enable is selected:
Intfc1 Rx Enable:
Enable Disable (E)
Using the W X arrow keys, select Enable to activate the receive (Rx) side of this interface, or
select Disable to de-activate the receive side of this interface. Press
ENTER
when done.
(CONFIG:) Intfc2 Gigabit Ethernet Æ Man
Intfc2 Management IP:
192.168.001.001/30 (▲ ▼ E)
Edit the Gigabit Ethernet Interface Management IP Address and Mask Range. This is the IP address
that can be used for one of two purposes:
• First, PING can be used with this IP address as a diagnostic tool to ensure the
interface is active and the external cabling in properly connected.