Comtech EF Data CDM-710G - Manual (Page 140)

CDM-710G High-Speed Satellite Modem Revision 1
Web Server Interface MN-CDM710G
7–10
7.3.3 Config Mdm (Configure Modem)
The ‘Config Mdm’ pages (Figure 7-6 through Figure 7-9) are used to configure all modem
parameters.
7.3.3.1 Config Mdm | Interface
Figure 7-6. Config Mdm | Interface page
Use the ‘Config Mdm | Interface’ page (Figure 7-6) to configure the modem’s installed data
interfaces. The appearance of this page is dependent on the interfaces installed in Expansion Slot
1 (Intfc1) and Expansion Slot 2 (Intfc2). In the above example, a CDI-60 HSSI Interface Module
has been installed in Expansion Slot 1, and a CDI-70 Gigabit Ethernet Interface (GBEI) Module
has been installed in Expansion Slot 2 (for a table of the applicable interfaces and installable
combinations, refer to Sect. 1.3.5 Allowable Data Interface Combinations).
For either slot, the modem automatically detects the interface present and adjusts the appearance
of this page accordingly. If needed, define the desired interface operating parameters, then click
[Submit Changes] to save these changes.