Comtech EF Data CDM-710G - Manual (Page 202)

CDM-710G High-Speed Satellite Modem Revision 1
Remote Control MN-CDM710G
A–12
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments for
Command or
Response to
Query
Description of Arguments
Response to
Command
Query
(Instruction
Code and
Qualifier)
Response to Query
Redundancy
State RED= 1 byte Command or Query.
Unit returns the redundancy state of the unit, where:
0 = Offline
1 = Online
*** This command can be used to force the unit offline, this is done by
sending RED=0. This is only valid if redundancy mode is enabled. If
redundancy is not enabled, then RED=0 will return an error. The unit
cannot be forced online.
*** If the unit is not in redundancy mode, then the unit will always be online.
Example: RED=0 (force unit offline)
RED=
RED?
RED*
RED# RED? RED=x
(see description of
arguments)
Gigabit Auto
Autocrossover SCX 2 bytes Command or Query.
s=Slot2 Only
a= 1 GBEI Cable Auto Crossover Enabled.
a=0 GBEI Cable Auto Crossover Disabled SCX=
SCX#
SCX?
SCX* SCX?s SCX=a
Gigabit
Learning Mode SLM 2 bytes Command or Query.
s=Slot2 Only
a= 1 GBEI Learning Enabled.
a=0 GBEI Learning Disabled SLM=
SLM#
SLM?
SLM* SLM?s SLM=a
Serial Number N/A 9 bytes Query Only.
Used to query the unit 9-digit serial number. Unit returns its S/N in the form
xxxxxxxxx.
Example: SNO=176500143
SNO?
SNO*
SNO# SNO? SNO=xxxxxxxxx
Software
Revision N/A 5 bytes Query Only.
Unit returns the value of the internal software revision installed in the unit,
in the form: Boot:X.X.X Bulk1:Y.Y.Y Bulk2: Z.Z.Z
Example: SWR=Boot:1.0.3 Bulk1:1.0.1 Bulk2:1.0.0
SWR?
SWR*
SWR# SWR? SWR=Boot:X.X.X
Bulk1:Y.Y.Y Bulk2:Z.Z.Z
Tx Alpha Rolloff TAR= 1 byte Command or Query.
Tx Alpha Rolloff, where:
0 = 20%
1 = 25%
2 = 35%
Example: TAR=0 (which is a Tx Alpha Rolloff of 20%)
TAR=
TAR?
TAR*
TAR# TAR? TAR=x
Tx Clock
Invert TCI=
2 bytes
Command or Query.
Invert Transmit Clock, where:
s=Defines which interface slot ( 1 or 2 )
x=Invert Transmit Clock, where:
0=Normal
1=Inverted
Note: Command valid with HSSI or E3T3STS1)
Example: TCI = 11 (selects Inverted TX Clock, Slot 1)
TCI =
TCI?
TCI *
TCI #
TCI?s
TCI =sx
(see description of
arguments)