Comtech EF Data CDM-710G - Manual (Page 226)

CDM-710G High-Speed Satellite Modem Revision 1
Remote Control MN-CDM710G
A–36
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments for
Command or
Response to
Query
Description of Arguments
Response to
Command
Query
(Instruction
Code and
Qualifier)
Response to Query
Faults and
Status (cont.) E= Encoder FIFO Empty
F= Encoder FIFO Full
G= SERDES Parity Errors
H=Reserved.I=Tx Ais Interface 1
J=Tx Ais Interface 2
K=Tx Cable Interface 1
L=Tx Cable Interface 2
c=Rx Traffic Status
0=No faults
1=+1.5V Demod Power Supply Unit (Demodulator Card)
2=FPGA Load (Demodulator Card)
3=Demod Unlocked
4=FPGA Temperature (Demodulator Card)
5=Ber Limit excedded
6=AGC Level Out of Range
7=Eb/No Limit Exceeded
8=Demodulator Synth 1 PLL
9=Demodulator Synth 2 PLL
A=SERDES Demod to Framer
B=SERDES Framer to FEC1
C=SERDES Framer to FEC2
D=Reserved(Fast Options)
E=Rx DCM Unlocked
F=Slot 1 Buffer Underflow
G=Slot 1 Buffer Overflow H Slot 2 Buffer Underflow I Slot 2 Buffer
Overflow J=Framer SERDES Rx Fault (Interface 1)
K=Framer SERDES Rx Fault (Interface 2)
L=Rx Clock Source Slot 1
M=Rx Clock Source Slot 1
N=Reserved.
O=Rx AIS Slot 1 Port1
P=RXAIS Slip Slot 2 Port1,
Q=EXT Clock Slot1,R EXT Clock Slot2
d=New Faults
0=No new faults
1=New faults, since last check
e=Configuration Change
0= No Configuration Change
1=Configuration Change (cleared when read)