Comtech EF Data CDM-710G - Manual (Page 114)

CDM-710G High-Speed Satellite Modem Revision 1
Front Panel Operation MN-CDM710G
6–38
(CONFIG:) Alarm Mask:
Æ Intfc1 (CDI-10-1 Single G.703 Interface Card)
Intfc1 E3T3STS1 Alarms:
Tx Rx ExtClk ( E)
Select Tx, Rx, or ExtClk using the ◄ ► arrow keys, then press
ENTER
.
If Intfc1 E3T3STS1 Alarms: Æ Tx is selected:
Intfc1 Port1 Tx Alarms:
Tx-Cable Tx-AIS ( E)
To configure each as an Alarm or Fault condition or to mask the alarm, select Tx-Cable or
Tx-AIS using the
W X arrow keys, then press
ENTER
.
If Intfc1 Port1 Tx Alarms: Æ Tx-Cable is selected:
Tx Cable Alarm:
Alarm Fault Mask ( E)
Select Alarm, Fault, or Mask using the W X arrow keys, then press
ENTER.
The default
selection is Alarm.
If Intfc1 Port1 Tx Alarms: Æ Tx-AIS is selected:
Tx-AIS Alarm:
Alarm Fault Mask ( E)
Tx-AIS Alarm affects the event reporting status upon detection of a Tx AIS condition, and
subsequently the switching logic, when the modem is in a 1:1 redundancy configuration.
Select Alarm, Fault, or Mask using the WX arrow keys, then press
ENTER.
The default selection
is Alarm.
If Intfc1 E3T3STS1 Alarms: Æ Rx is selected:
Intfc1 Port1 Rx Alarms:
Rx-AIS Buffer-Slip ( E)
To configure each as an Alarm or Fault condition or to mask the alarm, select Rx-AIS or Buffer-Slip
using the
W X arrow keys, then press
ENTER
.
If Intfc1 Port1 Tx Alarms: Æ Rx-AIS is selected:
Rx-AIS Alarm:
Alarm Fault Mask ( E)
This selection affects the event reporting status upon detection of a Rx AIS condition, and
subsequently the switching logic, when the modem is in a 1:1 redundancy configuration.
Select Alarm, Fault, or Mask using the W X arrow keys, then press
ENTER.
The default selection
is Alarm.