9 config: alarms, Config:) alarm mask: ( tx, Config:) alarm mask: ( rx – Comtech EF Data CDM-710G User Manual
Page 113: Config:) alarm mask: ( intfc1, 9 (config:)
CDM-710G High-Speed Satellite Modem
Revision 1
Front Panel Operation
MN-CDM710G
6–37
6.3.1.9
CONFIG: Alarms
Note: When the unit is in Remote mode and the user attempts to select an alarm state using the
W X
arrow keys, the following message displays (follow the prompt as shown):
THIS UNIT IS CURRENTLY
IN REMOTE MODE!!
DO YOU WANT IN LOCAL
MODE?ENT=Yes CLR=No
Otherwise, the following menu is displayed:
Alarm Mask: Tx Rx
Intfc1 Intfc2 ( E)
Select Tx, Rx, Intfc1, or Intfc2 using the
W X
arrow keys, then press
ENTER
.
(CONFIG:) Alarm Mask:
Æ Tx
Tx Alarm Mask: None
Currently, masking of Tx Alarms (associated with the modulator) is not allowed.
(CONFIG:) Alarm Mask:
Æ Rx
Eb/No Threshold Alarm:
Alarm Fault Mask ( E)
Select Alarm, Fault, or Mask using the
W X
arrow keys, then press
ENTER
.
(CONFIG:) Alarm Mask:
Æ Intfc1
The appearance of the menu branch for CONFIG: Alarms (Alarm Mask:) Æ Intfc1 is
dependent on whether the CDI-10-1 Single G.703 or the CDI-60 HSSI Interface card is installed
into Interface Slot 1.
Intfc1 E3T3STS1 Alarms:
Tx Rx ExtClk ( E)
Intfc1 HSSI Alarms:
Port1 Ext-Clk ( E)