Comtech EF Data CDM-710G - Manual (Page 81)

CDM-710G High-Speed Satellite Modem Revision 1
Front Panel Operation MN-CDM710G
6–5
6.1.4 Menu Matrix
Sect. Description Remarks
6.2 Opening Screen
6.3 Select (Main) Menu Select: Config; Monitor; Test; Info; Save/Load; Util
6.3.1 Configuration Select: Remote; Tx; Rx: Int1; Int2; Ref, Aux, Alarms
6.3.1.1 (CONFIG:) Remote Control Select: Local; Serial; Ethernet
6.3.1.2 (CONFIG:) Tx Select: FEC; Mod; Code; SymRate; Freq, Pwr; Scram
6.3.1.3 (CONFIG:) Rx Select: FEC; Dem; Code; SymRate; Freq; Eb/No; PLL
6.3.1.4
(CONFIG:) Intfc1
(CDI-10-1 E3T3STS1 Interface only)
Select: Tx; Rx; Config
6.3.1.5
(CONFIG:) Intfc1
(CDI-60 HSSI Interface only)
Select: Tx, Rx, CTS/RTS
6.3.1.6
(CONFIG:) Intfc2
(CDI-70 Gigabit Ethernet Interface only)
Select: Tx; Rx; Man; Stats; SWOP
6.3.1.7 (CONFIG:) Ref
6.3.1.8 (CONFIG:) Aux Select: Ena/Dis; Force (1:1)
6.3.1.9 (CONFIG:) Alarms Select: Tx; Intfc1; Intfc2
6.3.2 Monitor Select: Alarms; Rx_Stats; Event-Log
6.3.2.1 (Monitor:) Alarms Select: Transmit; Receive; Unit
6.3.2.2 (Monitor:) Rx Stats
6.3.2.3 (Monitor:) Event-Log Select: View; Clear-All
6.3.3 Test Select: Mode
6.3.4 Info Select: Rem; Tx; Rx; Intfc1; Intfc2
6.3.5 Save/Load Select: Save; Load
6.3.5.1 (Save/Load:) Save
6.3.5.2 (Save/Load:) Load
6.3.6 Utility Select: RT-CLK; Ref; ID; Display; Firmware; FAST
6.3.6.1 (Utility:) RT-Clk
6.3.6.2 (Utility:) Ref
6.3.6.3 (Utility:) ID
6.3.6.4 (Utility:) Display
6.3.6.5 (Utility:) Firmware Select: Info; Select
6.3.6.6 (Utility:) FAST Select: Cnfg; View
Notes:
1. Because the CDM-710G operates only in DVB-S2 mode, many of the Rx parameters are read-
only.
2. Refer to CONFIG: Tx Æ SymRate for the Data Rate table.
3. The Impedance selection appears when the 70/140 MHz Modulator card is installed.
4. Because the CDM-710G operates only in DVB-S2 mode, the Scrambler and pilot selections are
always available.