Comtech EF Data CDM-710G - Manual (Page 104)

CDM-710G High-Speed Satellite Modem Revision 1
Front Panel Operation MN-CDM710G
6–28
If Intfc1 Tx Æ Enable is selected:
Intfc1 Tx Enable:
Enable Disable (E)
Using the W X arrow keys, select Enable to activate the Tx side of this interface, or select Disable
to de-activate the Tx side and set the Data Rate to 0. Press
ENTER
when done.
(CONFIG:) Intfc1 HSSI Æ Rx
Intfc1 Rx:
Data Buffer Clock Enable
Select Data, Buffer, Clock, or Enable using the W X arrow keys, then press
ENTER
.
If Intfc1 Rx: Æ Data is selected:
Intfc1 Rx Data:
Datarate Invert (E)
Select Datarate or Invert using the W X arrow keys, then press
ENTER
.
If Intfc1 Rx Data: Æ Datarate is selected:
Intfc1 Data Rate:
Rx: 032.000000 Mbps
This is a read-only status message that indicates the Data Rate of the received MPEG-2 transport
stream. Press
ENTER
or
CLEAR
to return to the previous menu.
If Intfc1 Rx Data: Æ Invert is selected:
Intfc1 Rx Data Invert:
Normal Inverted (E)
To control data inversion (added for compatibility with certain older equipment), select Normal
or Inverted using the
W X arrow keys, then press
ENTER
.
If Intfc1 Rx Æ Buffer is selected:
Intfc1 Rx Buffer:
Size Recenter (E)
Select Size or Recenter using the W X arrow keys, then press
ENTER
.