Altera POS-PHY Level 4 IP Core User Manual
Page 110
A–4
Appendix A: Start-Up Sequence
Troubleshooting
POS-PHY Level 4 IP Core User Guide
December 2014
Altera Corporation
1. The PLL locked signal is not asserted or toggles. Ensure that the input clock jitter is
within the PLL jitter requirements. In some cases, if the PLL locked signal toggles,
the PLL must be reset. If so, perform the appropriate steps listed in
Table A–1 on
page A–2
. Refer to your PLL’s documentation for further information.
2. Data channel does not sync. This problem can be detected when
stat_rd_rdat_sync
remains low or toggles. The following tips may prove useful:
■
Ensure all resets are released.
■
Ensure all clocks are up, and measure clock frequencies.
■
Ensure training patterns are received.
3. Data channel syncs but only training patterns are received. This problem can be
detected when stat_rd_rdat_sync goes high, but no data is received, and
stat_rd_tp_flag
toggles. The following tips may prove useful:
■
For 128-bit receiver variations, ensure that the rxsys_clk to rdint_clk ratio is
set according to the receive clock setting in
■
Ensure that the calendar length and calendar multiplier are set to the same
values in both devices.
■
Verify timing requirements for the status channel
■
Select the clock edge that drives or samples the clock with ctl_ts_statedge
and ctl_rs_statedge.
■
Verify t
co
for the rsclk and rstat pins in the receiver IP core. The ALTDDIO IP
core keeps on-chip skew to a minimum.
■
Verify board skew for rsclk/rstat
■
Verify the setup and hold times for tstat on tsclk in the transmit IP core. The
ALTDDIO IP core keeps on-chip skew to a minimum.
■
Verify that tsclk is operating at the correct frequency.
4. Data channel syncs but stat_ry_disabled goes high or toggles. The rx_stat_phy
FIFO buffer may be underflowing or overflowing, due to incorrect configuration.
For guidance, refer to the relevant comments in
file (rx_stat_phy section, setting the thresholds).
5. Receive IP core detects DIP-4 errors during normal transmission. The following
tips may prove useful:
■
The receiver IP core (non-DPA variations) assume that the data is edge aligned.
The alignment can be changed at the receiver and transmitter. It is easier to
change the receiver by specifying a different alignment using the
INCLOCK_DATA_ALIGNMENT
parameter of the ALTLVDS IP core. In the
transmitter, the tdclk can be driven by a PLL clock output instead of a SERDES