Delta BLD-E1 brushless DC motor drive BLD-E1 Series - Manual (Page 61)

Chapter 4 ParametersAT |Troubleshooting}| BLD-E1 Series
4-20 Revision May 2009, 00DE, V0.50
Group 07 Protection Parameters
: The parameter can be set during operation.
Parameter Explanation Settings
Factory
Setting
VF VFPG FOCPM
07.00 Reserved
07.01 Reserved
07.02 DC Brake
Current Level
0~100% 0 ○ ○
07.03 DC Brake Time
during Start-up
0.0~60.0 sec 0.0 ○ ○ ○
07.04 DC Brake Time
during Stopping
0.0~60.0 sec 0.0 ○ ○ ○
07.05 DC Brake
Starting
Frequency
0~4000rpm (0.00~400.0Hz) 0.00 ○ ○
07.06 DC Brake
Proportional Gain
1~500 50 ○ ○
07.07 ~
07.10
Reserved
07.11 Fan Control 0: Fan always ON
1: 1 minute after brushless DC motor
drive stops, fan will be OFF
2: Brushless DC motor drive runs
and fan ON, brushless DC motor
drive stops and fan OFF
3: Fan ON to run when preliminary
heat sink temperature attained
4: Fan OFF
1 ○ ○ ○
07.12 Reserved
07.13 Reserved
07.14 Maximum Torque
Command
0 ～300% 100
○
07.15 ~
07.18
Reserved