Delta BLD-E1 brushless DC motor drive BLD-E1 Series - Manual (Page 130)

Chapter 4 Parameters| BLD-E1 Series
Revision May 2009, 00DE, V0.50 4-89
Content Address Function
Bit 4-5
00B: No function
01B: FWD
10B: REV
11B: Change direction
Bit 6-7
00B: 1st accel/decel
01B: 2nd accel/decel
10B: 3rd accel/decel
11B: 4th accel/decel
Bit 8-11 Represented 16 step speeds.
Bit 12
1: disable bit 06-11
00B: No function
01B: operated by digital keypad
02B: operated by Pr.00-15 setting
Bit 13~14
03B: change operation source
Bit 15 Reserved
2001H Frequency command
Bit 0 1: EF (external fault) on
Bit 1 1: Reset
Bit 2 1: B.B. ON
2002H
Bit 3-15 Reserved
2100H Error code: refer to Pr.06-16 to Pr.06-21
00: Stop
Status
monitor Read
only 01: deceleration
10: Ready for operation
Bit 0-Bit 1
11: operation
Bit 2 1:JOG command
00: FWD command, FWD output
01: FWD command, REV output
10: REV command, FWD output
Bit 3-Bit 4
11: Reserved
Bit 5 Reserved
Bit 6 Reserved
Bit 7 Reserved
Bit 8
1: Master frequency Controlled by communication
interface
Bit 9 1: Master frequency controlled by analog/external
terminals signal
Bit 10
1: Operation command controlled by
communication interface
Bit 11 1: Parameters have been locked
Bit 12 1: enable to copy parameter from keypad
2119H
Bit 13-15 Reserved
2102H Frequency command (F)
2103H Output frequency (H)
2104H Output current (AXXX.X)
2105H DC-BUS Voltage (UXXX.X)
2106H Output voltage (EXXX.X)
2107H Current step number of Multi-Step Speed Operation
2116H Multi-function display (Pr.00-04)