Delta BLD-E1 brushless DC motor drive BLD-E1 Series - Manual (Page 53)

Chapter 4 ParametersAT |Troubleshooting}| BLD-E1 Series
4-12 Revision May 2009, 00DE, V0.50
Group 03: Time Parameters
: The parameter can be set during operation.
Parameter Explanation Settings
Factory
Setting
VF VFPG FOCPM
03.00 Analog Input (VR) 0 ：No function 1 ○ ○ ○
03.01 Analog Input (ACI) 1 ：Frequency command (torque limit
under TQR control mode)
0 ○ ○ ○
03.02 Analog Input 3 2 ：Reserved 0
(AVI) 3 ： Preload input ○ ○ ○
4~6 ：Reserved
7: Positive torque limit ○
8: Negative torque limit ○
9: Regenerative torque limit ○
10: Positive/negative torque limit ○
03.03 Analog Input Bias
VR
-100.0~100.0% 0.0 ○ ○ ○
03.04 Analog Input Bias
ACI
-100.0~100.0% 0.0 ○ ○ ○
03.05 Analog Input Bias
AVI
-100.0~100.0% 0.0 ○ ○ ○
03.06 Positive/negative
Bias Mode VR
0 ○ ○ ○
03.07 Positive/negative
Bias Mode ACI
(can be set to 0 or
1 only)
0 ○ ○ ○
03.08 Positive/negative
Bias Mode AVI
0: Zero bias
1: Serve bias as the center, lower
than bias=bias
2: Serve bias as the center, greater
than bias=bias
3: The absolute value of the bias
voltage while serving as the center
(single polar)
4: Serve bias as the center (single
polar)
0 ○ ○ ○
03.09 Analog Input Gain
VR
0.0~500.0% 100.0 ○ ○ ○
03.10 Analog Input Gain
ACI
0.0~500.0% 100.0 ○ ○ ○
03.11 Analog Input Gain
AVI
0.0~500.0% 100.0 ○ ○ ○
03.12 Analog Input Delay
Time VR
0.00 ～2.00 sec 0.05 ○ ○ ○