Delta BLD-E1 brushless DC motor drive BLD-E1 Series - Manual (Page 34)

Revision May 2009, 00DE, V0.50 3-1
Chapter 3 Keypad and Start Up
3.1 Keypad
3.2 Operation Method
3.3 Trial Run
„ Make sure that the wiring is correct. In particular, check that the
output terminals U/T1, V/T2, W/T3 are NOT connected to power
and that the drive is well grounded.
„ Verify that no other equipment is connected to the motor.
„ Do NOT operate the brushless DC motor drive with humid hands.
„ Check if it displays 2000.0 on the digital keypad after power is
applied.
„ It should be stopped when fault occurs during running and refer to
“Fault Code Information and Maintenance” for solution. Please do
NOT touch output terminals U, V, W when power is still applied to
L1/R, L2/S, L3/T even when the brushless DC motor drive has
stopped. It may cause electric shock if touching the output
terminals U, V, W.