Metalfab SEW Eurodrive MOVIMOT MM..C - Manual (Page 7)

Operating Instructions – MOVIMOT® MM03C - MM3XC
7
2
Safety Notes
2 Safety Notes
• Never install damaged products or take them into operation. Please submit a com-
plaint to the shipping company immediately in the event of a damage.
• Only electrical specialists with the relevant accident prevention training are allowed
to perform installation, startup and service work on the MOVIMOT
®
. They must also
comply with the regulations in force (e.g. EN 60204, VBG 4, DIN-VDE 0100/0113/
0160).
• Preventative measures and protection devices must correspond to the regulations in
force (e.g. EN 60204 or EN 50178).
Necessary protective measures: Grounding of MOVIMOT
®
.
• The unit meets all requirements for reliable isolation of power and electronics con-
nections in accordance with EN 50178. All connected circuits must also satisfy the
requirements for reliable isolation so as to guarantee reliable isolation.
• Before removing the MOVIMOT
®
inverter, it must be disconnected from the supply
system. Dangerous voltages may still be present for up to one minute after discon-
nection from the power supply source.
• As soon as supply voltage is present at the MOVIMOT
®
, the terminal box must be
closed, i.e. the MOVIMOT
®
inverter must be screwed on.
• The fact that the status LED and other display elements are no longer illuminated
does not indicate that the unit has been disconnected from the power supply and no
longer carries any voltage.
• Mechanical blocking orunit-internal safety functions can cause a motor standstill. Re-
moving the cause of this problem or performing a reset can result in the motor re-
starting on its own. If, for safety reasons, this is not permissible for the driven ma-
chine, MOVIMOT
®
must be disconnected from the mains before correcting the fault.
• Danger of burns: The MOVIMOT
®
surface temperature (especially of the heat sink)
can exceed 60 °C during operation!
• If MOVIMOT
®
or field distributors are used for emergency stops, the supplemental
documentation "Safe shutdown for MOVIMOT
®
" must be observed. Only those com-
ponents may be used in safety applications that were explicitly delivered with this de-
sign by SEW-EURODRIVE!