Metalfab SEW Eurodrive MOVIMOT MM..C - Manual (Page 138)

138
Operating Instructions – MOVIMOT® MM03C - MM3XC
10
Diagnostics of MOVIMOT® with integrated AS-Interface
Diagnostics
"Monitor" window
description The following illustration shows the diagnostic monitor.
AS-i communication window area
• The "Inverter status" window area displays important information about the status of
the AS-Interface. The AS-i control outputs window area displays the current status of
the AS-i bits "D0 (CW/stop)", "D1 (CCW/stop)", "D2 (Setpoint f1/f2)" and "D3 (Reset/
controller inhibit)". An AS-i bit set by the master is identified by a green symbol.
• The "AS-i parameters" window area displays the current status of the AS-i parameter
bits. These bits are used to select the scaling factor. An AS-i parameter bit set by the
master is identified by a green symbol.
• The "MOVIMOT
®
parameters" window area displays information about the current
speed setpoint, the active scaling factor selected (via AS-i parameter bits) and the
ramp time selected via switch t1.
06460AEN