Rockwell Automation 1760-xxxx Pico GFX-70 Controllers User Manual - Manual (Page 80)

Publication 1760-UM002B-EN-P - March 2005
3-2 Commissioning
2. Press OK to confirm your choice and press ESC to exit the menu. GFX
will then switch to the Status display.
Operating Modes Pico GFX-70 operating modes - RUN, STOP and TERMINAL MODE.
In RUN mode the GFX continuously processes a stored program until you
select STOP, disconnect the power supply or switch to TERMINAL MODE.
The program, parameters and the GFX settings are retained in the event of a
power failure. All you will have to do is reset the real-time clock after the
back-up time has elapsed. Circuit diagram entry is only possible in STOP
mode.
The following applies to devices without display/keypad:
• Memory module containing a valid circuit diagram must be fitted.
• Device must be switched on.
If the device has no program, the program stored on the memory module is
loaded automatically and the device immediately starts running the program in
RUN mode.
IMPORTANT
You can change the language setting at a later date, if
you wish. See Changing the Menu Language on page 7-8.
If you do not set the language, the Pico GFX-70 will display
this menu every time you switch on and wait for you to
select a language.
IMPORTANT
In RUN mode, the processor will immediately run the
program saved in the unit when the power supply is
switched on. This will not happen if STOP or TERMINAL
mode was set as startup mode. In RUN mode, outputs are
activated according to the switch logic involved.