Rockwell Automation 1760-xxxx Pico GFX-70 Controllers User Manual - Manual (Page 266)

Publication 1760-UM002B-EN-P - March 2005
4-156 Wiring with Pico GFX-70
C 01C
is the counter coil of the counter 01 function block.
Figure 4.81 Pico GFX-70 wiring and circuit diagram
2. Keep the cursor on the number.
3. Press the OK button.
The first part of the parameter set of a counter is displayed.
4. Move the cursor down over the
+
character to the value input behind
>SH
:
–
>SH
means: function block input upper counter setpoint value
– The
+
character means that the parameters of this timing relay can be
modified using the PARAMETERS menu.
5. Change the upper counter setpoint to 10:
– Use the left and right arrow buttons to move the cursor onto the tens
digit.
– Use the up and down arrow buttons to modify the value of the digit.
6. Press OK to save the value and ESC to return to the circuit diagram.
7. Enter the circuit diagram up to contact
T 01
of the timing relay. Set the
parameters for
T 01
.
IMPORTANT
If the cursor is on the contact number, Pico GFX-70 will
call up the parameter display when you press OK.
I 05---------------------------[ C 01C
I 06---------------------------[ C 01RE
C 01---------------------------[ T 01EN
T 01Q1-------------------------[ Q 01
C 01 +
>SH +10
>SL
>SV
IMPORTANT
Pico GFX-70 has specific parameter displays for the
function blocks. The meaning of these parameters is
explained under each function block type.