Rockwell Automation 1760-xxxx Pico GFX-70 Controllers User Manual - Manual (Page 337)

Publication 1760-UM002B-EN-P - March 2005
Pico GFX-70 Settings 7-9
Pico GFX-70 will now show the new menu language.
Press ESC to return to the Status display.
Changing Parameters Pico GFX-70 allows you to change function relay parameters such as timing
relay set point values and counter Setpoint without having to call up the circuit
diagram. This is possible regardless of whether Pico GFX-70 is running a
program or is in STOP mode.
1. Press OK to switch to the main menu.
2. Start the parameter display by selecting PARAMETERS.
All function blocks are displayed as a list.
The following preconditions must be fulfilled in order for a parameter set to
be displayed:
• A function relay must have been included in the circuit diagram.
• The PARAMETERS menu must be available.
• The parameter set must have been enabled for access, indicated by the +
character at the bottom right of the display.
SICUREZZA...
SISTEMA...
LINGUA MENU...
CONFIGURATORE...
T 03 S +
CP08 -
C 17 +
L: 1 RUN
IMPORTANT
Parameter sets can only be enabled or protected via the
FUNCTION RELAYS menu, or via the circuit diagram
with the “+” enable and with “-” inhibit parameter set
characters.