Rockwell Automation 1760-xxxx Pico GFX-70 Controllers User Manual - Manual (Page 344)

Publication 1760-UM002B-EN-P - March 2005
7-16 Pico GFX-70 Settings
Deactivating the P Buttons
1. Select
P BUTTONS
✓ .
2. Press OK.
Pico GFX-70 changes the display to
P BUTTONS
and the P buttons are
deactivated.
Startup Behavior The startup behavior is an important aid during the commissioning phase. The
circuit diagram which Pico GFX-70 contains is not as yet fully wired up or the
system or machine is in a state which Pico GFX-70 is not permitted to control.
The outputs should not be controlled when Pico GFX-70 is switched on.
Setting the Startup Behavior
Requirement: Pico GFX-70 must contain a valid circuit diagram.
1. Switch to the System menu.
2. Specify the operating mode which Pico GFX-70 must use when the
supply voltage is applied.
IMPORTANT
The P buttons are automatically deactivated when loading a
circuit diagram from the memory module or via PicoSoft
Pro to Pico GFX-70, or when deleting a circuit diagram in
Pico GFX-70.
IMPORTANT
The GFX models without a display can only be started in
RUN mode.
IMPORTANT
If Pico GFX-70 is protected by a password, the
System menu will not be available until Pico GFX-70
is “unlocked” (see Unlocking Pico GFX-70 on page
7-5).