Rockwell Automation 1760-xxxx Pico GFX-70 Controllers User Manual - Manual (Page 331)

Publication 1760-UM002B-EN-P - March 2005
Pico GFX-70 Settings 7-3
7. Save the new password by pressing OK.
8. Use OK to exit the password display and proceed with ESC and
Ú
to the
RANGE… menu.
The scope of the password has not yet been considered. The password is now
valid but not yet activated.
Selecting the Scope of the Password
1. Press the OK button.
2. Select the function to be protected or the menu.
3. Press the OK button to protect the function or menu (tick = protected).
• CIRCUIT DIAGRAM: The password is effective on the program with
circuit diagram and non-enabled function blocks.
• PARAMETERS: The PARAMETERS menu is protected.
• TIME: Date and time are protected with the password.
• OPERATING MODE: The toggling of the RUN or STOP operating
mode is protected.
• INTERFACE: The interface is inhibited for access to a connected
device. Programs or commands to other devices connected via the
Pico-Link are routed further.
• DELETE FUNCTION: After four failed attempts to enter a password,
the “DELETE FUNCTION?” prompt appears. This prompt is not
displayed if selected. However, it is no longer possible to make changes
in protected areas if you forget the password.
ENTER PASSWORD
000042
CIRCUIT DIAGRAM
✓ ▲
PARAMETERS
TIME
OPERATING MODE
▼
INTERFACE
DELETE FUNCTION
IMPORTANT
Standard protection encompasses the programs and circuit
diagram.
At least one function or menu must be protected.