Rockwell Automation 1760-xxxx Pico GFX-70 Controllers User Manual - Manual (Page 346)

Publication 1760-UM002B-EN-P - March 2005
7-18 Pico GFX-70 Settings
Possible Faults
Pico GFX-70 will not start in RUN mode:
• a program is not available in Pico GFX-70.
• you have selected Pico GFX-70 startup in STOP MODE (RUN MODE
menu).
Card Startup Behavior
The startup behavior with memory module is for applications where unskilled
personnel change the memory module under no-voltage conditions.
Pico GFX-70 only starts in the Run mode if a memory module with a valid
program is inserted.
If the program on the memory module is different to the program in Pico
GFX-70, the program from the card is loaded into the processor and the
processor starts in the RUN mode.
Switch to the System menu.
Activation of Card Mode
Requirement: RUN MODE is active.
If Pico GFX-70 displays
CARD MODE
✓ , this means that when the power
supply is switched on, Pico GFX-70 will only start in RUN mode if a memory
module with a valid program has been inserted.
1. Otherwise select
CARD MODE
and press OK.
Pico GFX-70 will start up with the program on the card.
2. Press ESC to return to the Status display.
IMPORTANT
If Pico GFX-70 is protected by a password, the System
menu will not be available until Pico GFX-70 is “unlocked”
(see Unlocking Pico GFX-70 on page 7-5).
DEBOUNCE
✓ ▲
P BUTTONS
RUN MODE
✓
CARD MODE
✓ ▼