Rockwell Automation 1404-M4_M5_M6_M8 Powermonitor 3000 User Manual, PRIOR to Firmware rev. 3.0 - Manual (Page 98)

Publication 1404-UM001D-EN-E - October 2004
4-38 Communications
Ethernet PCCC/CSP protocol
PCCC messaging is supported in the Series A Powermonitor 3000 and
in Series B units with communications firmware 1.22 and Master
Module firmware 2.5x or later.
You may set up messaging from legacy controllers such as PLC-5 and
SLC 500, to a Powermonitor 3000 with optional Ethernet
Table 4.11 Ethernet Message Types
Message type Series A Series B
CIP PLC-5 Typed Write • •
CIP PLC-5 Typed Read • •
CIP Generic Assembly Object (class 04), Get & Set Attribute Single
for Attribute 3 (data) • •
CIP Generic Assembly Object (class 04), Get Attribute Single for
Attribute 3 (size) • •
CIP SLC 500 Typed Write • (1)
(1) Available in communications FRN 1.21 or later.
CIP SLC 500 Typed Read • (1)
CIP Data Table Read (using CSP/PCCC addressing e.g. F15:0) • (1)
CIP Data Table Write • (1)
CSP / PCCC PLC-5 Typed Write • (2)
(2) Available in communications FRN 1.22 or later. Uses CIP Encapsulation on PCCC commands.
CSP / PCCC PLC-5 Typed Read • (2)
CSP / PCCC Protected Typed Logical Read, 2 address fields • (2)
CSP / PCCC Protected Typed Logical Read, 3 address fields •
CSP / PCCC Protected Typed Logical Write, 2 address fields • (2)
CSP / PCCC Protected Typed Logical Write, 3 address fields •
CSP / PCCC Word Range Read (2)
CSP / PCCC Word Range Write (2)
CSP / PCCC Diagnostic Loopback •
IMPORTANT
For future compatibility, it is recommended that you
use EtherNet/IP messaging with Series A
Powermonitor 3000 units.